You will need:
- leather or similar material in different colors – colorful leather for the cuff, black leather for the lining, contrast leather for the fringes
- leather cord in matching or contrast color
- 2 screw back stud closures
- glue, matching/contrast thread, scissors, punch pliers, pencil
1. Construct the pattern based on your personal measurements
2. Trace the pattern onto the left side of the leather, cut the cuff out and punch the holes for the stud closures. If your leather is thick enough you can skip the steps 3 and 4
3. Apply glue to the leather
4. Glue the top leather onto the lining-leather
5. Sew around the edges with contrast/matching thread
6. Punch bigger holes on one side of the bracelet for the stud closures
7. Attach the screw back stud closures
8. Punch two small holes in the center of the bracelet- one in the middle and one a little bit higher. The reason for the asymmetric holes is the bow technique
9. Make the bow
10. Tighten the bow, eventually secure it with some glue
11. Prepare small leather fringes for the bow
12. And finely glue the fringes around the bow ends
2 Comments
Sabrina
18. March 2015 at 2:04 PMDas muss ich auch mal versuchen. Sieht echt toll aus
FASHIONAVENTURA
22. March 2015 at 9:20 PMCute 🙂 M&MFASHIONBITES mmfashionbites.blogspot.gr
Maria V.